Search
Register
Only Admins can see this message.
Data Transition still in progress. Some functionality may be limited until the process is complete.
Processing Attachment, Gallery - 187.18163%

Floor tom brackets Last viewed: 8 hours ago

Posts: 908 Threads: 291

I have an older 1970s Pearl set

I am just looking or searching for good used brackets for my floor tom

Please can you give me some idea of where to look at

Which is kind of better to get ,Just like the ones I have or just get a different brand to put back on there

Why I am looking .One of mine are ready stripped out and I had to re threaded it .LOL I know that want last long

Posted on 12 years ago
#1
Posts: 6583 Threads: 644

Put a pic on...I have a few pairs of MIJ FT brackets...may have.......

"Always make sure your front bottom BD lugs clear the ground!"
Posted on 12 years ago
#2
Posts: 908 Threads: 291

Picture

I was just wondering where can I get three of this at

Man , LOL if you going to buy one why not re place them all

Posted on 12 years ago
#3
Posts: 6583 Threads: 644

Think I have them...might be a week till I can get to them......anyone else has them sooner ....go ahead and grab from them

"Always make sure your front bottom BD lugs clear the ground!"
Posted on 12 years ago
#4
Posts: 908 Threads: 291

Is it something Better then what I have on them or what or just about the same thing ..

Don't some one makes these ....Or will they fit or what

Posted on 12 years ago
#5
Posts: 908 Threads: 291

Mr Blaire

You think have these .Ok you look for them and you get back to me ,OK

Posted on 12 years ago
#6
Posts: 908 Threads: 291

how others brands that might fit it

Just asking

LOL really I just hate when they Strip out the threads

when it dose that it's really hard to re threaded it back in again and make it tight up again

Fills like it might strip out again .Just have to be so careful on them .

Posted on 12 years ago
#7
Posts: 908 Threads: 291

Please if anybody out there that might up me with this

Posted on 12 years ago
#8
Posts: 6583 Threads: 644

I tried to help...but you wouldn't even give me the exact hole spacing on your parts....just "I think they are over 2" "....that doesn't help 1 bit.......

"Always make sure your front bottom BD lugs clear the ground!"
Posted on 12 years ago
#9
Posts: 908 Threads: 291

My problem is I just can't read a Tape measure that good

Might be what you said .be over 2 inch ....

What do you might think it is .You know about drums better then I do

Posted on 12 years ago
#10
  • Share
  • Report
Action Another action
Something else here